Encoder Disc and Sensor 417
Removal & Installation
Encoder Disc and Sensor
Removal
1. Remove the Left Cover
⇒
See page 270
.
2. Remove:
• For the 42-inch model, the Left Connector Cover
⇒ See page 287.
• For the 60-inch model, the Electronics Module
Extension⇒ See page 288.
3. Remove the Ink Supply Station ⇒ See page 321.
4. Disconnect the Encoder Sensor cable from the
PrintMech PCA.
5. Release the Encoder Sensor cable from the clip located
on the Electronics Module.
WARNING!: Switch off the printer and remove the power cable.
CAUTION: Please handle the Encoder Disc very carefully since any finger prints, scratches or
stains could cause the Printer to malfunction.
To Next Page
Loading...