442 Chapter 8 Removal & Installation
Removal & Installation
Take-Up Reel Motor
Removal
1. Close the Paper Bin (if open).
2. Disconnect the Take-Up Reel Motor from the Parallel
Port on the rear of the printer.
3. Remove the two rear T-20 screws that attach the Take-
Up Reel Motor to the Right Leg Assembly.
4. Loosen the two front T-20 screws that attach the Take-
Up Reel Motor to the Right Leg Assembly.
WARNING!: Switch off the printer and remove the power cable.
To Next Page
Loading...