Preventive Maintenance 461
Preventive Maintenance
“Maintenance #1 required”
The following message is triggered depending on the total quantity of ink spitted in each Spittoon.
“Maintenance #2 required”
Once one of the maintenance advised messages is displayed, the preventive maintenance kit must be
used to replace the most worn parts of the printer. Use the Removal and Installation Chapter of this Service
Manual as a guide to replace the necessary parts.
The following PM Kit covers both Maintenance advised messages:
Preventive Maintenance Kit #1
This Preventive Maintenance Kit #1 contains the following components:
• Encoder Strip
⇒
page 331
• Encoder spring+Nut
⇒
page 332
• Carriage PCA Cover
⇒
page 334
• Belt Tensioner Assembly
⇒
page 347
• Cutter Assembly
⇒
page 319
• Redial Retainer Assembly
⇒
page 437
• Line Sensor Cable
⇒
page 390
• Air Purges (Setup Printheads)
• Aerosol foam protector
⇒
page 391
• Carriage Assembly (with Encoder sensor)
⇒
page 339
(does not include PCA, Cutter, nor Color
Sensor).
• Ink Supply Tubes and Trailing Cable
⇒
page 312
.
• Tubes retaining clip
⇒
page 278
• Scraper Assembly and Absorber Foams
⇒
page 303
• Scan-Axis Motor
⇒
page 346
.
• Belt Assembly
⇒
page 345
.
You must also clean the holes in the Service Station which are located under the Maintenance Cartridge
and that the Aerosol Fan is funcioning correctly.
Preventive Maintenance Kit #2
This Preventive Maintenance Kit #2 contains the following components:
• Aerosol Filter
⇒
page 300
.
• SVS Aerosol Fan assembly ROHS
⇒
page 300
.
• Ink Absorber
⇒
S
ee User’s Guide
• Left spittoon
⇒
page 328
.
• Color Sensor
⇒
page 392.
• Line Sensor
⇒
page 390.
• Encoder Strip
⇒
page 331
You must also clean the holes in the Service Station which are located under the Maintenance Cartridge
and that the Aerosol Fan is funcioning correctly.
To Next Page
Loading...