Step 1: Removing the consumables from the printer 467
Repacking
•
Once all the Print-heads are removed, close the carriage latch and close the window.
•
Open the Right Door (Service Station door) and manually pull the SVS Carriage up to the
front.
•
Remove the Maintenance Cartridge. Re-packaging instructions are also provided. Please,
take special care when handling the cleaner. It may be full of ink so do not flip over or you
will get a severe ink spill.
•
Remove the Ink cartridges on the left side of the printer.
Re-packaging the Ink consumables
The print-heads must be re-packed with its original packaging. This is the best way to ensure the pen health
during transportation.
The ORANGE caps must be reinstalled in the print-heads, then it has to be placed back into its container.
It can be sealed by some adhesive tape.
The ink cartridges must be stored back into its boxes.
The Maintenance Cartridge can be stored back into its bag, but to ensure no ink spills during manipulation
& transport, a zip plastic bag is recommended to properly seal this part.
To Next Page
Loading...