●
Check that neither side of the spindle core has end caps, and make sure the
spindle core is pushed firmly into both spindle guides.
●
If you are using a HP Designjet Z6100 42–in Printer, make sure that the bin
loop is placed behind the foot brace so that it does not block the take-up reel
sensors.
NOTE: If you want to load the take-up reel during printing, familiarize
yourself with the procedural steps. Loading the take-up reel during printing
requires you to complete the procedure while the printer is feeding and
printing paper. Loading the take-up reel during printing saves approximately
1 m (3 feet) of paper.
Attach a roll to the take-up reel
1.
On the printer's front panel, select the
icon, and then select Take-up
reel > Load take-up reel.
2. If you want to load the take-up reel now, select Load take-up reel now on
the front panel. If you want to load the take-up reel during printing, select Load
it during printing on the front panel.
3.
Make sure that the take-up reel deflector is in its upright position.
Unlock the take-up reel spindle by pushing the spindle lever to its uppermost
position.
Use the take-up reel
17
Handle the paper
To Next Page
Loading...
