9.
Press the OK button on the front panel. The printer advances the paper.
NOTE: Make sure that you insert the loop-shaping core. The take-up
reel will not function correctly without it. The loop-shaping core must
have end caps. Make sure that the end caps extend over the edges of
the paper.
10.
Carefully insert the loop-shaping core, and the press the OK button on the front
panel. The Ready message appears.
NOTE: You are not required to press the OK button if you are loading
the take-up reel during printing.
NOTE: Make sure the loop-shaping is inserted. The take-up reel will
not function correctly without it. The loop-shaping core must have end
caps. Make sure that the end caps extend over the edges of the paper.
When the printer is printing and the take-up reel is operating, the paper is fed
from the printer, drops down in a loop, and then up into the take-up reel spindle.
NOTE: While the take-up reel is operating, make sure that the take-
up reel sensors are not blocked.
Use the take-up reel
21
Handle the paper
To Next Page
Loading...
