7.
Use the wind-direction switch on the take-up reel motor to select the winding
direction. Setting 1 winds the paper so that the printed image faces in.
Setting 2 winds the paper so that the printed image faces out.
The front panel shows you to the correct setting based on the winding-direction
decision you made in step 5.
8.
Gently lower the take-up reel deflector, and then press the OK button on the
front panel. The printer advances the paper.
Assemble a loop-shaping core by matching the shape-coded and color-coded
lengths of plastic tubing. The loop-shaping core must be the same width as the
paper that you are using. Make sure that both end caps are firmly fitted on the
ends of the loop-shaping core.
NOTE: The front-panel display shows the required length of the loop-
shaping core based on the width of the roll that you have loaded into
the printer.
20 Chapter 2 Handle the paper
Handle the paper
To Next Page
Loading...
