6.
Pull the paper taut to the take-up reel spindle core. Do not attempt to pull more
paper out of the printer. Use tape to secure the paper to the spindle core. You
might need to use more tape than is shown in the following image. The paper
should be secure enough to support the weight of the loop-shaping core, which
you insert in step 10.
NOTE: If you are loading the take-up reel during printing you do not
need to pull the paper taut. Tape the paper to the spindle core when an
adequate length of paper has fed from the printer after printing begins.
NOTE: To avoid having the paper skew as it winds onto the spindle
core, make sure the paper is straight when you attach it. It is sometimes
useful to use the core grooves to align the paper.
Use the take-up reel
19
Handle the paper
To Next Page
Loading...
