3.
With a dry brush, remove ink deposits from the cutter groove.
4.
With the same dry brush, remove ink deposits from the platen surface.
5.
Use a clean, absorbent lint-free cloth that has been slightly dampened with isopropyl alcohol to wipe
loosened ink deposits from the platen.
NOTE: Isopropyl alcohol is not provided in the Maintenance Kit.
CAUTION: Do not use commercial cleaners or abrasive cleaners. Do not wet the platen
directly, because you will leave too much moisture behind.
6.
Use the damp cloth to clean the cutter ramp.
Clean the platen 137
Maintain the printer
To Next Page
Loading...
