●
Media Lever on page 383
●
Media Lever Sensor on page 386
●
Rear Ebox Cover on page 388
●
Interconnect Cables on page 389
●
Pinchwheel Assembly on page 390
●
Center Guide on page 395
●
Drive Roller on page 399
●
Right Roll-feed Module on page 407
●
Left Roll-feed Module on page 408
●
Take-Up Reel Motor on page 409
●
Take-Up Reel Left-Hand Module on page 411
●
Take-Up Reel Deflector Supports on page 412
●
Take-Up Reel Sensors on page 414
Introduction
This chapter is a step-by-step guide to the removal and installation of the key components of the printer.
You may find it useful to tick off the steps as they are performed. Use the illustrations for each
procedure to identify the parts referred to in the text.
The procedures appear in order of removal. So the whole machine can be stripped down by starting at
the beginning of this chapter and working through the subsequent procedures.
NOTE: Before using this chapter to remove and install a new component, always make sure that you
have performed the relevant service test from
Service tests and utilities on page 84. If the test passes
you will not need to replace the component.
Safety Precautions
Review the instructions identified by WARNING and CAUTION symbols before you service the printer.
Follow these warnings and cautions for your protection and to avoid damaging the printer.
WARNING! Serious shock hazard leading to death or injury may result if you do not take the
following precautions:
• Ensure that the AC power outlet (mains) has a protective earth (ground) terminal.
• Switch the plotter off, and disconnect it from the power source prior to performing any maintenance.
• Prevent water or other liquids from running onto electrical components or circuits, or through
openings in the module.
Electrostatic Discharge (ESD) Precautions
To prevent damage to the printer circuits from high-voltage electrostatic discharge (ESD):
1. Do not wear clothing that is subject to static build-up.
2. Do not handle integrated circuits (ICs) in carpeted areas.
ENWW
Disassembly order
211
Removal and
installation
To Next Page
Loading...
