HP Designjet Z6200

2. Rotate the Electronics Module Extension approximately 90 degrees counter-clockwise.
3. Remove the Electronics Module Extension from the printer.
Window Position Sensor
Removal
WARNING! Switch off the printer and remove the power cable.
1. Remove the Window:
●
For the 42-inch
See Window (42-inch) on page 213.
●
For the 60-inch
See Window (60-inch) on page 215.
2. Remove the Left Cover
See Left Cover on page 222.
3. Remove the Right Cover
See Right Cover on page 216.
4. Remove the Top Cover:
●
For the 42-inch
See Top Cover (42-inch) on page 224.
●
For the 60-inch
See Top Cover (60-inch) on page 229.
5. Remove the Right Connector Cover
See Right Connector Cover on page 238.
242 Chapter 8 Removal and installation ENWW
Removal and
installation