3. Install the Printheads once the utility has been completed successfully.
4. Reset life counter Carriage PCA
Reset Life Counters on page 108.
Carriage Flex Cables
Removal
WARNING! Switch off the printer and remove the power cable.
1. Remove the Right Cover See Right Cover on page 216.
2. Remove the Front Panel
See Front Panel on page 245.
3. Disconnect the Trailing Cable from the Carriage PCA.
4. Press the two side of the Carriage PCA Cover and unclip from the Carriage Assembly.
5. Use a flat bladed screwdriver to release the ALL the clips, securing the Carriage Flex Cables to the
Carriage Assembly, by pulling upwards.
ENWW
Disassembly order
299
Removal and
installation
To Next Page
Loading...
