9. Disconnect the OMAS Controller Card from the Formatter and remove it from the printer.
OMAS Cable
Removal
WARNING! Switch off the printer and remove the power cable.
1. Remove the Right Cover See Right Cover on page 216.
2. Remove the Right Connector Cover
⇒ See Right Connector Cover on page 238.
3. Remove the Service Station
See Service Station on page 252.
4. Remove the OMAS
See Optical Media Advance Sensor (OMAS) on page 316.
5. Remove one T-15 screw that secures the OMAS Cable clamp from the printer.
ENWW
Disassembly order
329
Removal and
installation
To Next Page
Loading...
