9. Unclip the Main PCA.
10. Remove the Main PCA.
Formatter
Removal
WARNING! Switch off the printer and remove the power cable.
CAUTION: Do not remove the Fan or the Processor (located under the Fan) from the Formatter. The
Fan and the Processor are part of the Formatter support part and should be replaced as one assembly.
1. Remove the EIO to PCI Interface Card See EIO to PCA Interface Card on page 324.
2. Remove the Main PCA
See Main PCA on page 335.
3. Remove the OMAS Controller Card
See OMAS Controller Card on page 326.
338 Chapter 8 Removal and installation ENWW
Removal and
installation
To Next Page
Loading...
