Removal and replacement procedures 36
1.
Press in the four tabs (two on the top and two on the bottom) to release the bezel blank from the
carrier.
2. Pull the bezel blank out of the carrier.
CAUTION: Do not discard the bezel blank. If the optical drive is removed in the future, you must
reinstall the bezel blank to maintain proper system function.
Figure 9 Removing the bezel blank
To install the optical carrier with optical drive:
1. Align the optical drive in the carrier and install drive.
2. Secure the optical drive to the carrier with the two mounting screws.
Figure 10 Assembling the optical drive and carrier
3. Slide the optical drive assembly into the chassis.
4. Secure the optical drive to the chassis with the screw.
To Next Page
Loading...
