Removal and replacement procedures 52
CAUTION: To prevent overheating or a possible system crash, use only a heat sink model specified
for the HP ProLiant DL180 G 5 server.
To install the heat sink:
1. Properly align the heat sink mounting screws to the system board mounting holes.
2. Tighten the mounting pins to secure the heat sink connection to the system board.
CAUTION: To prevent the heat sink from tilting to one side during installation and removal
procedures, use a diagonally opposite pattern (an “X” pattern) when loosening and tightening the
four spring-loaded screws. Do not over tighten the heat sink’s spring-loaded screws to prevent them
from breaking off. A maximum torque of 4 in-Ib is set for the system.
Figure 35 Installing the heat sink
To install the air baffle:
1. Align the air baffle hooks with the holes on the chassis.
2. Gently place in the air baffle.
To Next Page
Loading...
