Removal and replacement procedures 53
Figure 36 Installing the air baffle
Memory
The HP ProLiant DL180 G5 server has six DIMM slots that support up to 16 GB maximum system
memory.
You must adhere to the following guidelines when adding or replacing memory modules:
• For 2P system, both physical processors must be of the same type and speed.
• Use 533/677 MHz Registered ECC DDR2 Memory.
• Supported DIMM: 256 MB, 512 MB, 1 GB, 2 GB and 4 GB (16 GB maximum capacity) DDR2
SDRAM memory technologies for x 4 and x 8 devices.
• Supported configurations defined in the JEDEC DDR2 DIMM specification only.
Figure 37 DIMM slots
NOTE: Before installing the memory, remove the air baffle first. For detailed procedure, refer to the
“Processor” section in this chapter.
To Next Page
Loading...
