Removal and replacement procedures 59
Figure 46 Installing PCIe riser card (1)
Figure 47 Installing PCIe riser card (2)
Installing PCIe/PCI-X Riser Board
The system supports up to two riser boards at a time. Use only HP supported expansion boards that
meet the following specifications:
• Compliance
○ PCI Express x4 or x8
○ PCI-X (available only when the optional PCI-X riser board is installed)
• Form Factor
○ Low-profile
○ Full-Height/Full-Length
To remove the slot cover:
1. Remove the screw(s) that secure(s) the slot cover(s) to the chassis.
To Next Page
Loading...
