HP Dl180 - G6 E5504 2X2gb 4Lff Svr - Page 64

Removal and replacement procedures 64
Figure 55
Replacing the battery
System board removal and replacement procedure
To remove the system board:
1. Remove the top cover.
2. Loose the nine screws that secure the system board to the chassis.
3. Slide the system board back, up and out of the chassis. Remove the system board from the
chassis.
Figure 56 Removing the system board
To replace the system board:
1. Align the system board I/O connectors to their openings and slide the system into place. The
nine screw holes on the chassis should align with the system board.
2. Fasten the nine screws on the system board to secure the system board to the chassis.