Maintenance and Service Guide 5–1
5
Removal and Replacement
Procedures
This chapter provides removal and replacement procedures.
You must remove up to three screws (for the cable lock) when
servicing the docking station. Make note of each screw location
during removal and replacement.
Refer to Appendix A, “Screw Listing,” for detailed information
on screw sizes, locations, and usage.
5.1 Serial Number
Report the docking station serial number to HP when requesting
information or ordering spare parts. The serial number is located
on the bottom of the docking station.
Serial Number Location
To Next Page
Loading...
