-330,"Self-test
failed;
unexpected
Frat.-N
chip sweep interrupt"
Triggered by: *tst? command This is a hardware fault. Please report
error and returned value from "ST? command to service personnel.
-330,"Self-test failed; VCO 30
MHz
minus unlocked"
Triggered by: "st? command VCO unlocked
by
30
MHz
and minus
bit. This is a hardware fault. Please report error and returned value
from *TST? command to service personnel.
-330,"Self-test failed; VCO 30
MHz
plus unlocked"
Triggered by: *tst? command VCO unlocked by
30
MHz
and plus
bit. This is a hardware fault. Please report error and returned value
from
*TST? command to service personnel.
-330,"SeKtest failed; VCO 60
MHz
minus unlocked"
Triggered by: "tst? command VCO unlocked by
60
MHz
and minus
bit. This is a hardware fault. Please report error and returned value
from
*TST? command to service personnel.
-330,"Self-test failed; VCO 60
MHz
plus unlocked"
Triggered by: *tst? comma.nd VCO unlocked by
60
MHz
and plus
bit. This
is
a hardware fault. Please report error and returned value
from *TST? command to service personnel.
-330,"Self- test failed; Voltage calibration failed: level
FLIP
FLOP is
defect"
Triggered by: 'TST? command. This is a hardware fault. Please
'.I
report error and returned value from "TST? command to service
personnel.
-330,"Self-test failed; Voltage calibration failed: level never above low
signal peak"
Triggered by: "TST? command. This is a hardware fault. Please
report error and returned value from 'TST? command to service
personnel.
-330,"Self-test failed; Voltage calibration failed: level never above
high
signal peak"
Triggered by: 'TST? command. This is a hardware fault. Please
report error and returned value from *TST? command to service
personnel.
-330,"Self- test failed; Voltage calibration Wed: level never below high
signal peak"
Triggered by: *TST? command. This is a hardware fault. Please
report error and returned value from
*TST?
command to service
personnel.
-330,"Self-test failed; Voltage calibration failed: level never below low
signal peak"
Triggered by: *TST? command. This is a hardware fault. Please
report error and returned value from 'TST? command to service
-
personnel.
E-8
Error
Messages
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
