Smart card reader
Description Spare part number
Smart card reader L13690-001
Smart card reader plastic insert (for use in models without a smart card reader) L13692-001 (Plastics Kit)
Smart card insert L13692-001 (Plastics Kit)
Smart card reader cable (available in Cable Kit) L13678-001 (Cable Kit)
Before removing the card reader, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is o or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by rst unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
4. Remove the bottom cover (see Bottom cover on page 30).
5. Remove the battery (see Battery on page 43).
Remove the smart card reader:
NOTE: Before you remove the smart card reader, make sure nothing (memory card or plastic insert) in
inserted in the reader.
1. Disconnect the system board cable from the connector on the smart card reader board (1).
2. Disconnect the TouchPad cable from the ZIF connector on the smart card reader board (2).
3. Remove the three Phillips M2.0x2.5 screws (3) that secure the smart card reader to the computer.
56 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
To Next Page
Loading...
