17. If it is necessary to replace the WLAN antenna cables, peel the antennas from the top of the display
enclosure (1), remove the antenna cables from the routing path on the bottom of the display enclosure
(2), and then remove the antenna cables (3).
NOTE: The WLAN antennas are included with the display enclosure.
18. If it is necessary to replace the WWAN antenna cables, peel the antennas from the top of the display
enclosure (1), remove the antenna cables from the bottom and sides of the display enclosure (2), and
then remove the antenna cables (3).
NOTE: The WWAN antennas are included with the display enclosure.
The display enclosure is available as spare part number L60615-001 in models without a privacy display
and L72086-001 in models with a privacy display.
Reverse this procedure to reassemble and install the display assembly.
Component replacement procedures 73
To Next Page
Loading...
