3. Use a tool to release the module (3), and then remove the module from the computer (4). The module is
secured with adhesive.
Reverse this procedure to install the NFC module.
Fan
To remove the fan, use this procedure and illustration.
Table
6-10 Fan description and part number
Description Spare part number
Fan assembly M07102-001
Before removing the fan, follow these steps:
1. Prepare the computer for disassembly (Preparation for disassembly on page 33).
2. Remove the bottom cover (Bottom cover on page 33).
3. Disconnect the battery cable from the system board (see Battery on page 43).
Remove the fan assembly:
1. Disconnect the fan cable from the system board (1).
2. Remove the cables from the clips on the side of the fan (2).
Component replacement procedures 53
To Next Page
Loading...
