a. Flex the bottom (1), the left and right sides (2), and then the top of the bezel (3) to release it.
b. Remove the bezel from the display (4).
Bezels are available as the following spare part numbers:
NOTE: When replacing the bezel, be sure that the replacement bezel matches the original bezel.
● M08545-001: IR camera and ambient light sensor
● M08546-001: IR camera
● M08547-001: RGB camera and ambient light sensor
● M08548-001: RGB camera
● M15624-001: Microphone module only (no camera module)
7. If you need to remove the hinge cover from the display enclosure:
a. Remove the Phillips M1.6 × 3.0 screw (1) that secures the hinge cover to the display.
b. Slide the hinge cover toward the right (2).
c. Rotate the bottom of the hinge cover up, and then remove it from the display (3).
d. Note the location of all cables hidden by the hinge cover so that you can be sure to properly route
the cables during reassembly.
The hinge cover is available in the Hinge Kit as spare part number M08555-001.
Component replacement procedures 61
To Next Page
Loading...
