g.
Keyboard (see
Keyboard on page 76)
h. Base enclosure (see
Base enclosure on page 80)
i.
System board (see
System board on page 97)
j. Heat sink (see
System board on page 97)
Remove the processor:
1. Use a flat-bladed screw driver (1) to turn the processor locking screw one-half turn
counterclockwise, until you hear a click.
2.
Lift the processor (2) straight up, and remove it.
NOTE: The gold triangle (3) on the processor must be aligned with the triangle icon (4)
embossed on the processor socket when you install the processor.
Reverse this procedure to install the processor.
Component replacement procedures
105
To Next Page
Loading...
