5.
Remove the two Phillips PM2.5×11.0 screws from the docking connector alignment guides (3) that
secure the base enclosure to the computer.
6.
Remove the following screws that secure the base enclosure to the computer:
(1) One Phillips PM2.0×3.0 screw from the hard drive bay
(2) Two Phillips PM2.0×3.0 screws from the battery bay
(3) One Phillips PM2.0×4.0 broad head screw from the battery bay
(4) Two Phillips PM2.5×4.5 screws from the optical drive bay
7.
Position the computer with the battery bay toward you.
8.
Remove the four Torx TM2.5×8.0 screws (1) from the rear panel of the computer.
Component replacement procedures
81
To Next Page
Loading...
