Remove the service cover release latch assembly:
1. Position the base enclosure with the front toward you.
2.
Remove the service cover release latch actuator from the base enclosure.
3. Turn the base enclosure upside down, with the front toward you.
4. Remove the service cover release latch arm spring from the spring retention hooks on the service
cover release latch arm (1) and the base enclosure (2).
5. Slide the service cover release latch arm (1) as far to the left as it will go.
6. Flex the middle of the service cover release latch arm (2) up and back until it releases from the
track built into the base enclosure.
Component replacement procedures
87
To Next Page
Loading...
