Solid-state drive
Description Spare part number
512-GB Turbo Drive G2 solid-state drive supporting TLC 917926-001
256-GB Turbo Drive G2 solid-state drive supporting TLC 917925-001
256-GB M.2 SATA SED solid-state drive supporting Opal2 and TLC 917924-001
128-GB M.2 SATA-3 solid-state drive 917923-001
Before removing the solid-state drive, follow these steps:
1. Shut down the computer.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by rst unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the bottom cover (see Bottom cover on page 27).
5. Disconnect the battery cable from the system board (see Battery on page 29).
Remove the solid-state drive:
1. Remove the Phillips PM2.0×2.4 screw (1) that secures the solid-state drive to the system board. (The
solid-state drive tilts up.)
2. Remove the solid-state drive (2) by pulling the drive away from the slot at an angle.
Reverse this procedure to install the solid-state drive.
30 Chapter 5 Removal and replacement procedures
To Next Page
Loading...
