Fingerprint reader board cable
NOTE: The ngerprint reader board spare part kit does not include the ngerprint reader board cable.
The ngerprint reader board cable is included in the Cable Kit, spare part number 917893-001.
Before removing the ngerprint reader board cable, follow these steps:
1. Turn o the computer. If you are unsure whether the computer is o or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see Bottom cover on page 27), and then remove the following components:
a. Battery (see Battery on page 29)
b. Solid-state drive (see Solid-state drive on page 30)
c. Fan (see Fan on page 34)
d. Speakers (see Speakers on page 35)
e. System board (see System board on page 43)
Remove the ngerprint reader board cable:
1. Release the ZIF connector (1) to which the ngerprint reader board cable is attached, and then
disconnect the ngerprint reader board cable from the ngerprint reader board.
2. Detach the ngerprint reader board cable (2) from the keyboard/top cover. (The ngerprint reader
board cable is attached to the keyboard/top cover with double-sided adhesive.)
3. Remove the ngerprint reader board cable (3).
Reverse this procedure to install the ngerprint reader board cable.
48 Chapter 5 Removal and replacement procedures
To Next Page
Loading...
