Card reader board
Description Spare part number
Card reader board
NOTE: The card reader board spare part kit does not include the card reader board cable. The card
reader board cable is included in the Cable Kit, spare part number 917893-001.
917892-001
Before removing the card reader board, follow these steps:
1. Turn o the computer. If you are unsure whether the computer is o or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see Bottom cover on page 27).
5. Remove the battery (see Battery on page 29).
Remove the card reader board:
1. Release the ZIF connector (1) to which the NFC board cable is attached, and then disconnect the NFC
board cable from the card reader board.
2. Release the ZIF connector (2) to which the card reader board cable is attached, and then disconnect
the card reader board cable from the card reader board.
3. Remove the three Philllips PM2.0×2.4 screws (3) that secure the card reader board to the keyboard/top
cover.
4. Remove the card reader board cable (4).
Reverse this procedure to install the card reader board.
42 Chapter 5 Removal and replacement procedures
To Next Page
Loading...
