3. Release the ZIF connector (3) to which the webcam/microphone module cable is connected, and
disconnect the cable from the system board.
4. Release the WLAN antenna cables and the webcam/microphone module cable from the retention clip (4)
built into the top cover/keyboard.
5. Release the ZIF connector (5) to which the display panel cable is connected, and disconnect the cable
from the system board.
6. Release the display panel cable from the retention clip (6) built into the top cover/keyboard.
7. Remove the six Phillips M2.0 × 6.0 screws that secure the display assembly to the computer.
8. Swing the top edge of the display assembly (1) away from the top cover/keyboard. (The top cover/
keyboard disengages from the display assembly hinges.)
44 Chapter 5 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
