5. Remove the right speaker (4).
NOTE: When removing the right speaker, make note of the location of the rubber isolators (5). The
absence of or damage to these isolators can result in degraded right speaker performance.
6. Disconnect the left speaker cable (1) from the system board.
7. Release the antenna cable from the retention channel (2) built into the left speaker.
8. Remove the three Phillips M2.0 × 3.5 screws (3) that secure the left speaker to the computer.
9. Remove the left speaker (4).
NOTE: When removing the left speaker, make note of the location of the rubber isolators (5). The
absence of or damage to these isolators can result in degraded left speaker performance.
Reverse this procedure to install the speakers.
46 Chapter 5 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
