HP Engage One Retail System 141 - Connecting a Standalone I;O Connectivity Base to the Engage One; Configuring the I;O Connectivity Bases Powered Serial Ports

Connecting a standalone I/O connectivity base to the Engage
One
1. Prepare the computer for disassembly (Preparation for disassembly on page 19).
2. Connect the USB Type-C power cable to the USB Type-C port on the underside of the stand’s column and
to the USB Type-C power port on the I/O connectivity base.
3. Connect the I/O connectivity base’s power supply to the I/O connectivity base and a grounded AC outlet.
Conguring the I/O connectivity base’s powered serial ports
The serial ports can be congured as standard (non-powered) serial ports or powered serial ports. Some
devices use a powered serial port. If the serial port is congured as a powered port, devices that support a
powered serial interface do not require an external power source.
IMPORTANT: The system must be powered o before connecting or disconnecting serial port devices.
NOTE: The I/O connectivity base ships with all serial ports congured in standard non-powered serial mode
(0 volts) by default.
There are three voltage settings for each serial port.
●
0 volts
●
5 volts
●
12 volts
To change the voltage settings for a powered serial port:
1. Prepare the computer for disassembly (Preparation for disassembly on page 19).
22 Chapter 4 Removal and replacement procedures