3. Connect the USB cable to the ngerprint reader (1) and route the cable under the routing clip on the
ngerprint reader (2). Remove the mounting screw (3) from the underside of the I/O connectivity base,
and then attach the bracket on the ngerprint reader assembly to the underside of the I/O connectivity
base (4) using the screw that was removed from the base and the short screw included in the kit.
4. Connect the ngerprint reader cable to a USB Type-A port on the I/O connectivity base.
5. Reconnect the I/O connectivity base and computer power cords.
26 Chapter 4 Removal and replacement procedures
To Next Page
Loading...
