HP Engage One Retail System 145 - Attaching an I;O Connectivity Base to the Engage One

Attaching an I/O connectivity base to the Engage One
You can attach an I/O connectivity base to the bottom of the computer’s stand.
1. Turn o the computer properly through the operating system, and turn o any external devices.
2. Disconnect the power cords from the computer and I/O connectivity base.
IMPORTANT: Regardless of the power-on state, voltage is always present on the system board as long
as the system is plugged into an active AC outlet. You must disconnect the power cord and wait
approximately 30 seconds for the power to drain to avoid damage to the internal components of the
computer.
3. Remove the cover on the I/O connectivity base by removing the four screws on the underside of the I/O
connectivity base (1), and then lifting the cover o the I/O connectivity base (2).
4. Connect the USB Type-C power cable to the USB Type-C port on the underside of the stand’s column.
Attaching an I/O connectivity base to the Engage One 17