Power connector cable
Description Spare part number
Power connector cable (includes bracket) 767246-001
Before removing the power connector cable, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
Battery on page 31), and then remove the following components:
a. Optical drive (see
Optical drive on page 32)
b. Top cover (see
Top cover on page 39)
Remove the power connector board:
1. Turn the system board upside down, with the front toward you.
2. Remove the two Phillips P2.5x4.0 screws from the power bracket (1).
3. Remove the power bracket (2).
4. Release the power connector from the clip built into the system board (3).
Reverse this procedure to install the power connector cable.
Component replacement procedures 63
To Next Page
Loading...
