HP ENVY *360 15M - Computer Setup (BIOS), TPM, and HP Sure Start; Using Computer Setup; Starting Computer Setup; Navigating and Selecting in Computer Setup

c. Release the adhesive strip (1) that secures the display panel cable connector to the display panel.
d. Disconnect the display panel cable (2) from the display panel assembly.
e. Release the ZIF connector (3) to which the TouchScreen control board cable is connected, and then
disconnect the TouchScreen control board cable from the TouchScreen control board.
f. Release the display panel cable (4) from the retention clip built into the display panel assembly.
g. Remove the display panel assembly (5).
The display panel assembly is available using spare part numbers 924357-001 (15.6-in, UHD,
WLED, BrightView (3840×2160), UWVA,
ultraslim-at (2.6-mm), eDP1.3+PSR with TouchScreen)
and 925736-001 (15.6-in, FHD, WLED, BrightView (1920×1080), UWVA, slim-at (3.2-mm), eDP1.3
with TouchScreen).
8. If it is necessary to replace the TouchScreen control board:
NOTE: The TouchScreen control board can be removed and replaced without removing the display
assembly from the keyboard/top cover.
a. Remove the display panel assembly.
b. Release the ZIF connectors (1) to which the TouchScreen control board cables are connected, and
then disconnect the TouchScreen control board cables from the TouchScreen control board.
Component replacement procedures 55