7. If you need to replace the webcam module from the display enclosure, lift the webcam up to
disengage the adhesive tape that secures the webcam to the enclosure (1), and then disconnect
the webcam cable (2).
8. If you need to remove the display hinges, from each hinge remove the 3 Phillips PM 2.0x2.5
screws from the side of the hinge (1) and the 5 Phillips PM 2.5×2.5 broadhead screws from the
bottom of the hinge (2).
9. Remove the hinges from the display panel assembly (3).
Component replacement procedures
65
To Next Page
Loading...
