HP ENVY m7 - Windows 7 Backing Up, Restoring, and Recovering; Creating Backups; Creating Recovery Media to Recover the Original System

Power button board
Description Spare part number
Power button board (includes cable) For HP ENVY 15 Notebook PC computer models 762496-001
Power button board (includes cable) For HP ENVY 17 Notebook PC computer models 763708-001
Before removing the Power button board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4. Remove the battery (see
Battery on page 37),
5. Remove the optical drive (see
Optical drive on page 38).
6. Remove the top cover from the base enclosure (see
Base enclosure on page 41).
7. Remove the WLAN module (see
WLAN module on page 55).
8. Remove the subwoofer (see
Subwoofer on page 60).
9. Remove the system board (see
System board on page 63).
Remove the Power button board and cable:
1. Turn the top cover upside down, with the back edge toward you.
2. Remove the two Phillips screws securing the Power button board to the base enclosure (1).
3. Remove the Power button board (2).
Reverse this procedure to install the Power button board.
Component replacement procedures 77