5-71
Hardkey and Softkey Reference
LF Out
LF Out Amplitude
Use this softkey to scale the output of the signal at the LF OUTPUT connector. To
change the value, press the softkey once. The current value for LF output
amplitude is displayed in the active entry area. To enter a new value, rotate the
front panel knob until the desired value is displayed, use the up and down arrow
keys, or enter the value using the numeric keypad and press the
V, or mV
terminator softkey. The range of values allowed is 0 to 5 Vpk in increments from
1mV to 5V.
Softkey Location: Press
LF Out, LF Out Amplitude
Status after Normal Preset: 0V
SCPI Commands:
[:SOURce]:LFOutput:AMPLitude <val><unit>
[:SOURce]:LFOutput:AMPLitude?
LF Out Freq
Use this softkey to set the modulating frequency for the LF output signal when
you have selected the internal source as a function generator. To change the
frequency, press the softkey once. The current modulating frequency is displayed
in the active entry area. To enter a new frequency, rotate the front panel knob until
the desired value is displayed, use the up and down arrow keys, or enter the value
using the numeric keypad and press the
Hz or kHz terminator softkey. The range of
frequencies allowed is 0.1 Hz to 10 kHz. (0.1 Hz to 50 kHz is the range allowed if
sinewave is selected as the internal waveform.)
This softkey is only active when you have selected the internal source to operate
as a function generator.
Softkey Location: Press
LF Out, LF Out Source, Function Generator, LF Out Freq
Status after Normal Preset: 400 Hz
SCPI Commands:
[:SOURce]:LFOutput:FUNCtion:FREQuency <val><unit>
[:SOURce]:LFOutput:FUNCtion:FREQuency?
To Next Page
Loading...
Need help?
General
