5-187
Hardkey and Softkey Reference
Utility
RTS On
Press this softkey to turn the RTS line on. In this mode, the instrument will ignore
the state of the CTS line (3-wire connection). This setting is intended for use with
an HP 83300A Remote Interface, but it will also work with a 3-wire connection.
RTS On is the default setting for the signal generator.
RTS is a persistent state; it is not affected by an instrument preset or by a power
cycle.
Softkey Location: Press
Utility, HP-IB/RS-232, RS-232 Pace, RTS/CTS, ON
SCPI Commands:
:SYSTem:COMMunicate:SERial:CONTrol:RTS ON
:SYSTem:COMMunicate:SERial:CONTrol:RTS?
Save User Preset
Use this softkey to establish your user-defined preset state. Set up all of the
instrument state conditions that you want for your unique preset state. When you
have defined the instrument state to suit your needs, press
Save User Preset. Only
one user-defined preset state is allowed, so when you save the instrument state
you will save over any previously-saved state. Your instrument state will be
recalled by the signal generator any time you press
Preset as long as you have set
the
Preset Normal User softkey to User. For additional information about the
Preset Normal User softkey, refer to its description in this section.
The user’s state definition is a state file; it is not affected by an instrument preset
or by a power cycle.
Softkey Location: Press
Utility, Power On/Preset, Save User Preset
SCPI Commands:
:SYSTem:PRESet[:USER]:SAVE
To Next Page
Loading...
Need help?
General
