Operating the Monitor
4–16 User’s Guide
Entering User Modes
The video controller signal may occasionally require a custom user
mode if you are not using a standard graphics adapter or pre-set
mode. In this condition, you may need to create a user mode. You
can use the OSD to:
■ Create a user-defined mode with custom monitor screen
parameters.
■ Readjust the parameters of any user mode.
■ Save them in memory. The monitor automatically stores the
new setting, then recognizes the new mode just as it does a
pre-set mode.
Ten user modes can be entered and stored, in addition to the
factory pre-set modes (see the table “Factory Pre-set Video Input
Modes” in Appendix B).
To Next Page
Loading...
