18
3.6 Parking Mode
To monitor the vehicle when it is parked, you can activate Park Mode.
Before you activate Parking Mode, please install ACC cable through
professional car service shop.
Follow the steps below to set up Parking Mode:
1. Press button to enter the OSD menu. Recording will be stpped.
2. Choose Parking Mode and press
OK
to enter the setting
.
3. Press
/
button to select ON, and press
OK
button to
activate.
4. Press
button to return to preview screen.
5. When the setting is finished, disconnect ACC, the camcorder will
enter Parking Mode automatically. When a collision is detected, the
device will auto power on and trigger Emergency Recording for 30
seconds.
Note:
1. ACC cable is not included in the package. Please ask for more information from your
distributor.
2. When in Parking Mode, if the device detects low voltage of battery, the device will
automatically power off to save the battery.
3. Parking Mode supports dual cam recording.
4. Emergency recordings will be saved in the “Emergency” folder and will not be overwritten by
the normal looping recordings.
3.7 Collision Detection
If the Collision Detection function is enabled, this camcorder begins
emergency recording once it detects any collision. Sensitivity of the
Collision Detection function is set to Normal by default, if user wants to
change the settings of Collision Detection, do the following:
1. Press
button to enter the OSD menu.
2. Select Setting and press
OK
button for confirmation.
3. Press / button to select Collision Detection, and press
OK
button for confirmation.
4. Press
/
button and select the High, Middle or Low sensitivity.
5. Press
button to return recording screen.
To Next Page
Loading...
