To Next Page

To Previous Page

Chapter 3 35

Installation

Installing the hardware and software

the chassis assembly. Use the screw you saved earlier to attach the card’s

bulkhead to the chassis.

Step 13. Close the cabinet.

Step 14. Re-attach all of the cables and wires.

Step 15. Connect the A.C. power cable.

Step 16. Power on the system.

Step 17. Continue with the section titled “Installing the software” at the end of

this chapter.

Questions and Answers:

Need help?

Do you have a question about the HP HP-UX 10.20 and is the answer not in the manual?

HP HP-UX 10.20 Specifications

General