Chapter 1 7
Safety and Regulatory Information
Regulatory Information
1 Safety and Regulatory
Information
Regulatory Information
This product was tested for conformance to various national and
international regulations and standards. The scope of this regulatory
testing includes electrical and mechanical safety, electromagnetic
emissions and immunity.
When required, approvals are obtained from third party test agencies.
Approval marks appear on the product label. In addition, various
regulatory bodies require some information under the headings noted
below.
FCC Statement (USA only)
This device complies with part 15 of the FCC rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits of a
Class A digital device, pursuant to part 15 of FCC rules. These limits are
designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy, and
if not installed and used in accordance with the instruction manual, may
cause harmful interference to radio communications. Operation of this
equipment in a residential areais likely to cause harmful interference, in
which case the user will be required to correct the interference at his own
expense.
Any changes or modifications not expressly approved by
Hewlett-Packard could void the user’s authority to operate this
equipment.
To Next Page
Loading...
Need help?
General
