Chapter 3 37
Installation
Installing the Software
control scripts for the fileset, and builds the kernel. The estimated
time required for processing will be 3 - 5 minutes.
11.When the status field indicates “Ready”, a Note Window will open.
Activate the “OK” button on the Note Window to reboot the system.
Step 2: Quick verify process
This section allows you to verify that the hardware, device driver, and
SwiftAPI function correctly.
1. After re-booting the system (see step 11 in the previous section),
change into the /opt/cryptofast subdirectory.
2. run csdiag -1
Sample Output (example has two SpeedCards)
>csdiag -l
Praesidium SpeedCard Diagnostics & Maintenance
Accelerators
Accelerator Hardware Firmware BIOS
Card 0 103c:2.0.0 2.0.22 0.0.0
Card 1 103c:2.0.0 2.0.22 0.0.0
3. If the csdiag diagnostic program outputs a list of accelerators similar
to the output above, the hardware, device driver and SwiftAPI are
working properly.
Step 3: Install the Netscape plug-in module
This procedure installs the Netscape plug-in module.
1. Make sure that the Netscape Server has already been installed and
the SSL secure protocol is functional. Point a web browser to
https://<servername> to verify.
NOTE For instructions on how to setup SSL under Netscape, please refer to
Netscape documentation.
To Next Page
Loading...
Need help?
General
