HP Integrity rx2660 - Manual

RX2660 BOOT DISK ENTRY
Effective:
12/18/18
Revision:
A
All information contained in this document is the sole property of HSQ Technology. Any reproduction in part or whole without the written
permission of HSQ Technology is prohibited.
PAGE: 1 of 11
Adding a Boot Disk Entry to an
HP Integrity rx2660
Necessary Items
• Terminal Emulator application (e.g., PuTTY).
• Hard drive to be mounted.
Overview
In order to boot an rx2660 to a “new” disk, it is necessary to add an entry to the list of devices the rx2660 will try
to boot from (i.e., add a boot entry).
• Connect to the Management Processor (MP).
• Power on the rx2660.
• From the MP, connect to the Console Terminal (CO) and watch the Power On Self Test (POST) and early
boot.
• When the Extensible Firmware Interface (EFI) Menu appears, go to Add Boot Option and add the Boot
Option for the disk.
• Still in the EFI Menu, go to Change Boot Order and move your disk to the top of the list.
• Boot from the disk.