RX2660 BOOT DISK ENTRY
All information contained in this document is the sole property of HSQ Technology. Any reproduction in part or whole without the written
permission of HSQ Technology is prohibited.
PAGE: 2 of 11
Details
In this example, a network connection is made to the Management Processor PDQVCA, which is in an rx2660
that plays the role of PDQVSA in the PDQ system.
1. With the rx2660 initially powered OFF (but still plugged in), insert the new hard drive into an available
slot.
2. Launch a PuTTY session and select either the Telnet or SSH radio button.
3. Connect to the MP and enter the Command Menu (CM). From any running workstation.
PDQVS1$ ssh "Admin@192.0.200.226"
Admin's password:
– OR –
PDQVS1$ telnet "Admin@192.0.200.226"
Admin's password:
NOTE: When using SSH, nothing appears in response to keystrokes, not even dots or asterisks.
Authentication successful.
Hewlett-Packard Integrity Integrated Lights-Out 2
(c) Copyright Hewlett-Packard Company 1999-2011. All Rights Reserved.
MP Host Name: pdqvca
Revision F.02.26
MP MAIN MENU:
CO: Console
VFP: Virtual Front Panel
CM: Command Menu
SMCLP: Server Management Command Line Protocol
CL: Console Log
SL: Show Event Logs
HE: Main Help Menu
X: Exit Connection
[pdqvca] MP> CM
4. Power up the main part of the rx2660.
[pdqvca] MP:CM> pc -on
PC -on
System will be powered on.
Confirm? (Y/[N]): y
y
-> System is being powered on.
-> Command successful.
[pdqvca] MP:CM>
To Next Page
Loading...
