14
Cisco Nexus B22 Fabric Extender for HP Getting Started Guide
Configuring the Cisco Nexus B22 Fabric Extender for HP
06/22/2011 22:09:48.198227: Deleting route to FEX
06/22/2011 22:09:48.203294: Module disconnected
06/22/2011 22:09:48.204160: Offlining Module
06/22/2011 22:09:48.204977: Module Offline Sequence
06/22/2011 22:09:48.527385: Module Offline
06/22/2011 22:10:23.644325: Module register received
06/22/2011 22:10:23.645444: Registration response sent
06/22/2011 22:10:23.864695: Module Online Sequence
06/22/2011 22:10:25.289316: Module Online
This example shows how to display the Fabric Extender interfaces pinned to a specific switch interface:
switch(config-fex)# show interface ethernet 1/19 fex-intf
'Fabric FEX
Interface Interfaces
---------------------------------------------------
Eth1/19 Eth100/1/4 Eth100/1/3 Eth100/1/2 Eth100/1/1
This example shows how to display the switch interfaces that are connected to a Fabric Extender uplink:
switch(config-fex)# show interface fex-fabric
Fabric Fabric Fex FEX
Fex Port Port State Uplink Model Serial
---------------------------------------------------------------
100 Eth1/19 Active 1 N2K-B22HP-P FOC1514256S
100 Eth1/20 Active 2 N2K-B22HP-P FOC1514256S
100 Eth1/21 Active 3 N2K-B22HP-P FOC1514256S
100 Eth1/22 Active 4 N2K-B22HP-P FOC1514256S
switch(config-fex)#
Note The above example shows a Fabric Extender with four uplink connections, only one of which is currently
active.
This example shows how to display the SFP+ transceiver and diagnostic optical monitoring (DOM)
information for Fabric Extender uplinks:
switch# show interface ethernet 1/40 transceiver
Ethernet1/40
sfp is present
name is CISCO-EXCELIGHT
part number is SPP5101SR-C1
revision is A
serial number is ECL120901AV
nominal bitrate is 10300 MBits/sec
Link length supported for 50/125mm fiber is 82 m(s)
Link length supported for 62.5/125mm fiber is 26 m(s)
cisco id is --
cisco extended id number is 4
switch# show interface ethernet 1/40 transceiver fex-fabric
Ethernet1/40
sfp is present
name is CISCO-EXCELIGHT
part number is SPP5101SR-C1
revision is A
serial number is ECL120601U0
nominal bitrate is 10300 MBits/sec
Link length supported for 50/125mm fiber is 82 m(s)
Link length supported for 62.5/125mm fiber is 26 m(s)
cisco id is --
cisco extended id number is 4
To Next Page
Loading...
